![]() I hope this can save souls who have been suffering over this problem! Thanks for reading. If you don't want any of this to happen at all and are too lazy to draw slow strokes, set the stabilizer to 0. The Surface Pro 6 detaches from the keyboard to give you a dedicated drawing device. Surface 3 Pen already offers a nice drawing experience. Surface Pro 4 Pen has a felt-like tip compared to the hard plastic tip of the Surface 3 Pen. One side is cut flat and that's where there's a strong magnet that will latch on to the side of SP4. It now has great accuracy, 4,096 levels of pressure, and tilt sensitivity. This is the new Surface Pen designed for the SP4. * You can avoid this by following through with your stroke or drawing your stroke slower. The N-trig Surface Pen is a lot better than it used to be. ![]() * You can decrease this probability from happening by drawing your stroke slowly or follow through with your stroke while lifting the pen up slower, or setting minimum size to 0. I have observed that if you lift up your pen quickly while drawing a line, the line may abruptly stop or produce a hooked tail at the end. Pressure and accuracy for SAI using Surface Pro 4 may be wonky at a few times. If you want smooth lines, set your stabilizer to a higher digit. If you want accurate lines, set your stabilizer to 0. Open sai.exe and test out if pressure works. Save the changes you have made to the nfig file and close.Ĥ. Honestly I have no idea what will happen if you don't put the commas or the empty lines but if it works this way it's best not to fiddle around too much.ģ. Remember to put commas and leave a line after "DenySuspend" and before "File Settings". After that, following the code pattern visible in the config file, type in this: Open the nfig in your SAI file, and scroll down to where "System Settings" is located.Ģ. After looking at how the nfig file works, with a little bit of "coding", I was able to get SAI to use TabletPC API and thus have pressure!ġ. After trying out SAI2 and fiddling w/ the settings, I discovered that enabling "Use TablePC API instead of WinTab" allowed pressure sensitivity with my Surface Pro 4 (woohoo!).īut when I went to the settings of older versions of SAI, the setting "Use TabletPC API" was not available. EDIT2018: I have been told that this no longer works on models newer than SP4! If Sai pressure no longer works on your device, I recommend that you either get Sai2, or use alternative programmes.ĮDIT2017: this solution is really old, so i cant help you definitely with issues you may experience from trying this! cant guarantee it'll help 100%, but if it works, it works.įor a while now, I couldn't get my Surface Pro 4 to have pressure in Paint Tool SAI.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |